18 Years manufacturer Bottom price for M5-M64 of Anchor Bolt with Stainless Steel in Poland Factory for Algeria
We support our buyers with ideal high quality products and high level service.Becoming the specialist manufacturer in this sector,we have gained rich practical experience in producing and managing.Our 18 Years manufacturer Bottom price for M5-M64 of Anchor Bolt with Stainless Steel in Poland Factory for Algeria, We are sincerely welcome good friends from numerous circles at dwelling and abroad come to cooperate!
Screw Conveyor for Besan Mix Pouch Packing Machine.
Conveying Material :Besan Mix, Turmeric Powder, Chilly Powder, Spices Powder, Flour, Salt, Sugar, Chilly Powder
Conveying Capacity: Up to 5 Tone/hour
Hopper Storage Capacity : 50 kg, 100 kg, 150 kg, 200 kg, 250 kg, 300 kg, 350 kg
Stirrer Suitable to Product.
Trolley : Movable, Fixed, Mild Steel, Stainless Steel, SS, MS
Material Of Construction: Mild Steel, Stainless Steel 304, SS 316, SS 202,…….
Discharge Height:4 feet 12 feet from Ground Level
Inclination Degree : Up to 55 Degree( Depends on Discharge height & space availability)
Orion Pulse 150s – Pulse arc and resistance welder
A sharpened 1mm tungsten electrode is used for the welds and should generally extend from the nose cone no more than a ¼”. It can be helpful to maintain a clean, sharp tip for easy weld actuation and consistent results. The argon shielding gas pressure is set to 10psi for best coverage. A copper flat jaw alligator grounding clip is used to hold the components during the welds.
Although it is not necessary, balling the tip of the wires prior to the welding process can facilitate the attachment to the screws. This can be done in a single weld actuation and the size of the ball can be increased or decreased by adjusting the energy accordingly. We used this technique on the stainless steel wires with the Orion Pulse 150i set at 2ws energy with Sloped Agitation enabled (a high frequency energy overlay that helps increase penetration and weld strength).
All three wires were attached to the stainless steel screws at 2ws energy with sloped agitation enabled. The screw is held in the grounding clip and the wire can be held anywhere along the outer ridge of the screw head or on the top surface of the screw head. The electrode is aimed at the surface of the screw near the tip of the wire and the material of the wire is drawn into the weld puddle. It is important to maintain contact of the wire and the surface of the screw during the weld for proper attachment.
The smaller tungsten wires become somewhat brittle in the heat affected zone and can break off more easily than the larger diameter tungsten so we would recommend using the larger diameter if possible. The wires can be attached to the top surface without damaging the slot for the screwdriver.
The Orion 150s is able to attach the wires to the stainless steel and titanium screws .
Let us know if you have any questions.
Toll Free Phone: 1-877-786-9353
Website: www. SunstoneEngineering.com