8 Year Exporter Customized Supplier for Cheap price Hex Flange Head Bolt (M5-M20) for Curacao Factory for Cologne Factory from Oman
We are experienced manufacturer. Wining the majority of the crucial certifications of its market, our 8 Year Exporter Customized Supplier for Cheap price Hex Flange Head Bolt (M5-M20) for Curacao Factory for Cologne Factory from Oman, items won certifications with the regional and international primary authorities .For far more detailed information,please contact us!
Used- Bonnot Extruder, Model 4″. Approximately 4″ diameter x 29″ long 304 stainless steel screw. Approximate 12″ long carbon steel barrel jacket section. 7″ x 11″ Feed throat, no hopper, with a counter-rotating paddle. Extruder driven by a 7.5hp, 3/60/230/460 volt, 1760 rpm XP Reeves variable speed motor, ratio 70.6 to 1, rpm minimum 6, maximum 60. Includes a die plate with approximate ¼” diameter holes, and a 2 blade fly knife cutter, driven by a 2hp, 3/60/230/460 volt, 1730 rpm Reeves variable speed motor, ratio 5.1 to 1, rpm minimum 130, maximum 520. Mounted on a carbon steel frame. SO# 6842, serial# 2520, built 1977.
This is a video of installing a product manufactured by Rhino. The carbon fiber straps were installed on 4′ centers, but 2′ from corners. I ended up installing 16 straps in my basement. I used Rhino straps in the areas that had the largest cracks, and then found a carbon fiber strap supplier on ebay that sold me the rest from a carbon fiber spool at a much cheaper price for the areas that didnt look that bad. I cannot confirm the quality of the “china” straps and may be sub-par compared to Rhino’s straps, but I thought it was low risk in my application and I saved a few hundred bucks. However, I used Rhino epoxy for all of them though. Amazon sells their products and Rhino has great customer support.
Disclaimer: I am not a licensed installer, and my installation methods are not in strict accordance to Rhino’s installation instructions. Rhino has an installation video on youtube, link below:
Consult a structural engineer for professional advice on the type of repair that is recommended for your application.
For the DIY’er, here is a list of stuff you’ll need
-DEWALT DWE46151 5″ Grinder
– DEWALT DW4777T 5-Inch XP Turbo Diamond Cup Wheel
-1-1/8″ 10A SDS Variable Speed Rotary Hammer
-3/4″ SDS Drill Bit
-Mastercraft Maximum 18V Drill/Driver
-Mastercraft Maximum 18V NiCad 3KO Impact Wrench
-Rhino Epoxy Gun
-Vacmaster VK811PH HEPA Vac 8Gal
-3M Half Facepiece Reusable Respirator 7500
-3M 2091 P100 Particulate Filter (pair)
-3M 6001 Organic Vapor Cartridge (pair)
-DeWalt DPG82-11C Concealer Anti-Fog Goggles
-RHINO WALL REPAIR KIT RCF-8′
-Rhino Rhino Epoxy
-Rhino 600gsm CF straps, 5.2″ wide x 8′ long
-Carbon Steel Bracket, 3/16″ thk, 1.25″ x 8″