China Gold Supplier for Blue White Zinc Plated Carriage Bolt (DIN 603) Factory from Salt Lake City
We support our buyers with ideal high quality products and high level service.Becoming the specialist manufacturer in this sector,we have gained rich practical experience in producing and managing.Our China Gold Supplier for Blue White Zinc Plated Carriage Bolt (DIN 603) Factory from Salt Lake City, We are sincerely welcome good friends from numerous circles at dwelling and abroad come to cooperate!
The flangs and pipe are threaded.
1. Put the flange in a vice and forced the pipe on the non lip side. (backwards). Leave the flang on the bar. You can tack weld if desired.
2. Force the other flange on (backwards), then remove flange. this will help screwing it on later
If you you can’t screw the flang on backwards it will screw on the correct way (lip side in).
Sink a slightly wider hole to accommodate the lip (1/4 inch) in the wood. Then Sink a hole for the pipe all the way through the wood.
You may need to improvise or modify these plans, be creative.
Share what you have done diffrently in the comments.
This is what happens if you dont drill a hole and mount it to the inside of the posts.
Thanks for the likes! dont forget to subscribe.
Check out my website I have a do it your self equipment page.
Like me on facebook
Pull up bar supplies
Two 4×6 x 10ft 37.14
One 1 x 72 Gas Pipe 22.48
Three 50 lb Quikrete 14.94
Two 1 inch floor Flanges 19.92
One can Paint 3.98
One 1 3/8 Steel Flat Bit 5.65
Eight 2 inch x 1/4 bolts & washers 3.12
I recommended a drill guide 29.96
Follow me on:
Night OPS II – 7/23/2016
An airsoft event hosted by East Coast Airsoft and Robinhood Paintball.
Need gear? Check out East Coast Airsoft! Looking for a place to use that gear? Head on over to Robinhood Paintball!